Tutorial Icon
QF-Test Tutorial version vidéo

Tutoriel en version vidéo: Nous vous guidons pas à pas à travers QF-Test...

Stepping Through a Test or Sequence

Now let's step through the test case we set up in the previous section.

  • Action Please try out the debugger buttons Single stepStep-In , Step overStep-Over and Step outStep-Out.

You will find that Single stepStep-In opens a node containing child nodes and makes the first child node the active node. Continuing from where we left the test suite at the end of the last section, i.e. in debugging mode, with 'Test case: First' being the current node, the test suite would now look like this:

Step in
Figure 14.4:  Stepping into a node

In the case of leaf nodes (nodes without child nodes), the effect of Step-In is the same as the following button's.

Step overStep-Over runs the current node including all children. Execution pauses at the next node of the same level to be executed, which then becomes the active one.

Step over
Figure 14.5:  Stepping over a node

Step outStep-Out runs the remaining nodes at the same level including their child nodes. Execution pauses when a node that is higher in the hierarchical structure is found, which then becomes the active one.

Step out
Figure 14.6:  Stepping out of a node

In the given example the node higher in the hierarchical structure where execution stops is the 'Cleanup' node. As explained in the chapter A full Test Run this shows the special behavior of Setup / Cleanup nodes in a test set: They are executed before and after each test case to help achieving a proper starting state for each test case.

Note You will only find this behavior when you started the whole test suite or test set and are in debugging mode. If you just selected the test case and did a step-over action then QF-Test will execute the test case and then select the next test case node.

  • Action Run the 'Cleanup' and 'Setup' nodes by stepping over them, using the debugger button Step overStep-Over and then Step in the second test case via Step-In to get ready for the next section where you will learn about the skip functionality.

Note Please be aware that menus or comboboxes tend to close when the application looses the focus, as will happen when activating the debugging mode. In such a case you should not stop test execution between the node opening the menu or combobox and the node performing the selection. One way to do achieve this is to set a break point Continue after the node performing the selection and to activate normal test execution by releasing the pause button Continue when you reach the node opening the menu or combobox.