2017 up to now  | 2016 | 2015 | 2014 | 2013 | 2012 | 2011 | 2010 | 2009 | 2008 | 2007

(older archive entries before 2007 are not shown here, but included in the onsite-search)

Mailing List - Entries of 2011

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [QF-Test] setup and cleanup in the batch mode

  • Subject: Re: [QF-Test] setup and cleanup in the batch mode
  • From: "Sobel, Adam (NSN - PL/Wroclaw)" <adam.sobel@?.com>
  • Date: Thu, 8 Dec 2011 15:23:39 +0100

We don't want to do everything in one command ,the idea is to invoke commands separately on the same running application.
For example:
1.Executing test(login.qft) from the command line.The result is that application is started(setup) and still running.
2.Executing test(connect.qft)from the command line.Some action is made on the same application started by the previous test(login.qft).
3.Executing test(disconnect.qft) from the command line which make cleanup and terminate application.
This is possible with the demon mode correct?   


-----Original Message-----
From: ext Gregor Schmid [mailto:Gregor.Schmid@?.de] 
Sent: Thursday, December 08, 2011 8:33 AM
To: qftest-list@?.de
Cc: Sobel, Adam (NSN - PL/Wroclaw)
Subject: Re: [QF-Test] setup and cleanup in the batch mode

Hello Adam,

when QF-Test terminates from batch mode it also shuts down the SUT.
There are two ways to avoid that:

- Perform everything in a single batch by specifying all test-suites
  on the command line instead of running one batch command per suite

- Run QF-Test in daemon mode and interact with that, either by writing
  your own daemon driver or by running 

  qftest -batch -calldaemon

The first solution is definitely simpler and sounds like the one you

Best regards,

"Sobel, Adam (NSN - PL/Wroclaw)" <adam.sobel@?.com> writes:

> Hi,
> We are testing qf-test tool for the new project.We have many tests and
> each test step  is in sepearate .qft file.
> I was trying to execute test in the batch mode but the application is
> closed immediatelly after test is finished.
> Is it possible not terminating the application after invoking one
> qft.file?After that I wanted to execute other test step (other file)
> from the command line on the same running application without
> setup/cleanup.
> Best regards
> Adam 
Gregor Schmid                                Gregor.Schmid@?.de
Quality First Software GmbH                     http://www.qfs.de
Tulpenstr. 41                               Tel: +49 8171 38648-0
DE-82538 Geretsried                         Fax: +49 8171 3864816
GF: Gregor Schmid, Karlheinz Kellerer          HRB München 140833